Router Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi,

Our shop has a Holzher Sprint edger, after being switched back on after being off over christmas it has error codes popping up when you go to start it once it reaches temp.
errors are:
8- Error inverter
4- Feed v- error inverter
4- 1802 - error inverter
2- 1940 motor circuit switch
2- 1918 motor circuit switch

Any ideas on what causes these? guy who usually looks after edger is on holidays still

Thanks
Dan
 

·
Official Greeter
Ross
Joined
·
11,145 Posts
Welcome to the forum Dan. I can’t help but maybe others will come along and give some advice.
 

·
Official Greeter
Joined
·
19,736 Posts
Welcome to the forum @D'Vaughn This is an older post and may not get a response...
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top