Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
133 Posts
Discussion Starter · #1 · (Edited)
This a Creative Woodworks pattern that I have made several times. The scrolled part is 1/4 inch Birch plywood. The back is also 1/4 inch Birch plywood that I painted and then glued the two halve together. The frame is scrap oak pieces glued together and planed to 1 inch thick. I then cut the oak to size and routed the edges on my router table with a 1/4 inch roundover bit.

I think I got it!
 

Attachments

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top