Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
394 Posts
Discussion Starter · #1 ·
Anyone have a homemade router fence that has an easy to adjust depth-of-cut feature? Not in a position to 'buy' a router fence, but I do have a sheet of 1/2" Baltic Birch just waiting to be used up in jigs/fences, etc.

I'm starting my woodworking learning curve on picture frames, and the constant 'bump and hope' method of my current rip fence mounted router fence is really not a good/accurate way to go as far as I can tell.

TIA.
 

·
Registered
Joined
·
394 Posts
Discussion Starter · #10 ·
Thanks for that picture Aaron, that gives me a few ideas to try. I just finished making my plates from some 'recovered from the dumpster' 3/4" plexiglass. Hope to get started on a router table this weekend.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top