Router Forums banner
1 - 1 of 1 Posts

·
Marine Engineer
Doug
Joined
·
4,960 Posts
I also keep it simple. For small measurements, I use the brass set up bars. For bigger distances, I set it up close as I can with a tape measure or machinist scale then test it on some scrap.

Once or twice I have cut a gage block on the table saw and used that to set the fence the right distance away for some dados I was cutting in the sides of a bookcase.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top