Router Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
342 Posts
Discussion Starter · #1 ·
Can I use a honing stone to get a little more life out of my carbide tipped router bits?

If I can, what would be the best type of stone to get?

thanks,
Greg
 

· Registered
Joined
·
342 Posts
Discussion Starter · #3 ·
thanks BJ...I'm using a 1/2" point cutting roundover bit to cut a lot of grooves in MDF.
It doesn't take long before I feel the bit dulling. I'll probably try to find a flat diamond honing stone with a real fine grit to try to touch-up the cutting face.

Greg
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top