The April 2004 FWW edition has an article on building "A versatile Router Table". This looks like a sweet, low-cost open table that allows for horizontal, overhead or vertical routing. Looks inexpensive to build as well. Page 58.
Horizontal Router Table
I will be building a Horizontal Router Table within the next few months.
This will be used to make Base Moldings and Crown Moldings mostly.
If you have any suggestions on the construction of this new tool please
send them to me.I think ill use a Hitachi 3 1/4 hp model plunge.I ordered a catalog from RBI to see the model they offer,for some ideas.
This will be used to make Base Moldings and Crown Moldings mostly.
If you have any suggestions on the construction of this new tool please
send them to me.I think ill use a Hitachi 3 1/4 hp model plunge.I ordered a catalog from RBI to see the model they offer,for some ideas.
1 - 4 of 4 Posts
This might give you some ideas
http://www.woodhaven.com/detail.aspx?ID=91
http://www.woodhaven.com/detail.aspx?ID=91
Looks like it might get a little rough doing wide work. Looks like the material will need extra support to hold it into the cutter.
Reminds me of a guillotine.
Reminds me of a guillotine.
1 - 4 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
