Router Forums banner
1 - 1 of 4 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I will be building a Horizontal Router Table within the next few months.
This will be used to make Base Moldings and Crown Moldings mostly.
If you have any suggestions on the construction of this new tool please
send them to me.I think ill use a Hitachi 3 1/4 hp model plunge.I ordered a catalog from RBI to see the model they offer,for some ideas.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.