Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
23,784 Posts
Hi Ed

I made one like this and used it for putting in mortise slots and it worked great for that but for most of the cuts it wanted to pickup the stock and pull it out of my hands.
I tried to use a feather board but it did the same thing but with a jam on the molding bit that shot the stock across the shop like a arrow.
I said that's it, gone.
I had it hanging on the back side of the router table then I took it off and gave the parts to my son to make a router table.
But I still have 2" x 1 1/2" slot for the bit in my router table and the vac. pickup port.

Please Let me know how it works out for you.

Bj :)
 

·
Registered
Joined
·
23,784 Posts

·
Registered
Joined
·
23,784 Posts
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top