Router Forums banner
1 - 2 of 27 Posts

· Premium Member
Retired since June 2000
15,066 Posts spin a 3/4" straight bit in a PC template guide with a 25/32" ID?
Not only can you NOT see what the bit is doing but the likelihood is that the dust will build up and cause lots of heat, not good for the bit! Two reasons why I design most of my templates to use a 40mm template guide. This shot illustrates what I mean.


  • Like
Reactions: jw2170
1 - 2 of 27 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.