Router Forums banner
1 - 3 of 3 Posts

·
Retired Moderator
Joined
·
16,385 Posts
You could make them with a router and straight edge/pattern or flush trim bit too. Just set the straight edge flush at the middle of the caul and back 1/32 or so at the end (depending on the flex in the board) and then repeat for the other end.
 

·
Retired Moderator
Joined
·
16,385 Posts
Or you could spend a small fortune and buy them from Woodpecker. They have been pushing them lately. 😳
I think we need an emoji that stands for "I think I'll pass on that".
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top