Router Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
1,783 Posts
I own a mastercraft spin saw kit and cannot figure out how or where I would put on a guide bushing?
Do I need to purchase something else?
What I am looking at (Googling) is a rotary trim cutter and it does not accept guide bushings. You would need a Router plate that accepts guide bushings and the router to match.
 

·
Official Greeter
Joined
·
19,833 Posts
Welcome to the forum.
 

·
Super Moderator
Joined
·
585 Posts
welcome to the forum, CL - knowing the exact model number and photos of your setup may help with the most accurate responses.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top