Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
95 Posts
Well I have heard not to make a pass that is any deeper than half the diametre of the bit you are using. I use it as a general rule of thumb and it seems to work. However, it does worry me that if I chuck up a 12mm straight flute and try to take off 6mm in one pass that it is too much. In this case I only take off 3mm at most. So I guess what I am saying is 3mm cut maximum. (ALthough the last cut I make is a very light one to clean it up).

Hope this is not too confusing.
Aaron
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top