Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter · #1 ·
I am curious to know if someone has a reference table as to how many passes should be done when ,let's say for an example, a spiral or straight-cutting bit is used to make a desired slot.Of course this depends on the thickness of material and its density or type( Hardwood as opposed to softwoods).My owner's manual does tell me what speeds to use according to pliability of woods being cut,but not if it can be completed in 1 pass.Any ideas..................
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top