First: I am a bit of a newbie, hope this is the right place to ask the question.
I have inherited a couple of routers from a neighbor's husband. One of them is a CMT1 (apparently identical to Trend T10).
In the box where these really long bits, along with a holder. The holder (part to the left in first image) looks like it would fit the CMT (has two holes on the side), but there seems to be no thread for it : router has a fine outside thread that fits a collet. The bit holder also has an outside thread.
Can't see if I need to remove something / replace something on the router ?
I received no instruction book.
I have inherited a couple of routers from a neighbor's husband. One of them is a CMT1 (apparently identical to Trend T10).
In the box where these really long bits, along with a holder. The holder (part to the left in first image) looks like it would fit the CMT (has two holes on the side), but there seems to be no thread for it : router has a fine outside thread that fits a collet. The bit holder also has an outside thread.
Can't see if I need to remove something / replace something on the router ?
I received no instruction book.