Router Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I am new but have a specific need; as attached diagram; thanks

its a need for a special jig setup or maybe my lack of knowledge suggests it can be done with normal router?; someone mentioned templates but not sure what they are?

D
 

Attachments

·
Premium Member
Joined
·
3,437 Posts
If I'm reading your attachment correctly, you already have the templates in metal and in correct size?
Trace that on mdf making your pattern 1/8" larger, perhaps use a flush trim bit for correct sizing?
 

·
Registered
Joined
·
93 Posts
Druis

I am new but have a specific need; as attached diagram; thanks

its a need for a special jig setup or maybe my lack of knowledge suggests it can be done with normal router?; someone mentioned templates but not sure what they are?
Did you get the answers you were looking for??

Ric :confused:
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top