Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
110 Posts
I would use a spiral downcut bit, not a straight bit. Also, since you are not using the CNC to cut out the parts, I would not pay for a compression bit. All that said, since you are not cutting these on the CNC, how are you positioning them after you have cut them out on the bandsaw? I would think that it must be a bear to set X0Y0 on a piece like that already cut out.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top