Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I need to purchase a router that I can mount on a table that has a power stock feeder running about 20’ per minute. It will be used to cut a ½” wide ¼” deep channel in 5” wide 10’ long boards. After setting the correct height for the router bit the router will remain untouched until a new bit is needed. The router will need to have an accurate height adjustment and remain solidly in place. Which router and brand should I buy? I’m putting my Porter-Cable 890 routers in the garbage.
 

·
Registered
Joined
·
23,786 Posts
HI Gus

You will need two tools to do what you want.
1st. one of the many 3 1/4HP routers .
2nd a power feed device, Grizzly sells many types.
see link below. :)

http://www.grizzly.com/products/G4173
http://www.grizzly.com/products/G4176
http://www.grizzly.com/products/category.aspx?key=560030

Routers
http://www.google.com/products?q=3+1/4+HP+router&btnG=Search+Products
http://www.amazon.com/s/ref=nb_ss_h...keywords=3+1/4+HP+router&Go.x=8&Go.y=10&Go=Go


NOTE**** don't trash can your PC tell Bj about it and he will buy it from you.

Bj :)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top