Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
902 Posts
Dewy said:
I'm going to the Trend T11 which like the CMT is based on the old Elu now made as the DeWalt DW625. The T11 has a larger plunge and cutter opening so perfect for use in a table especially as it has the fine height adjustment from both to & bottom for table use without needing a route rlift in the table.
The fine height adjuster on the T11 is a bit of a pig to use as the crank supplied isn't big enough I am afraid. I still think there is no better way than to remove the springs and use the normal fine height adjuster. a Raizer would be nice but too expensive for a tight wad like me. :D Personally I would opt for the CMT as this is very similar to the old Elu 177 and the De Walt 625.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top