Router Forums banner

Incra Magnalock plate is not flat !

1338 Views 1 Reply 2 Participants Last post by  DesertRatTom
Checking my new Incra Magnalock aluminum plate, with a steel ruler, and found it dead flat on three sides but the fourth side is high in the middle by about 0.015 inch. Don’t know if this is typical.

Has anyone successfully flattened their plate ?

thinking about clamping plate to a flat surface to bend it flat.
1 - 2 of 2 Posts
Send it back and get a replacement. Incra is a great and ethical company and should give you a replacement without any problem.
  • Like
Reactions: 2
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top