Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
151 Posts
Discussion Starter · #1 ·
I finally got the Sawstop fence for my CNS installed so the Incra setup is off, cleaned up and ready for a new home. It's a great fence system but my shop is too small and it's a PITA to use ripping wide panels, I have to roll the saw out from the wall so the positioner can extend. So I just replaced it with the Sawrtop T-Glide

Here's what you're getting:

1) TS-LS 32 joinery package
2) Large-saw conversion kit(never used)
3) TS router table support hardware(brackets only, I have no idea where the angles went)
4) shop-built router table top 26-5/8"w, 25-3/4"d, 1-5/16" thick, laminated Baltic Birch ply with Formica all sides, cutout for Jessem/Incra lift(9-1/4" x 11-3/4")

Pics are attached, the rails aren't in the pics but I have them, they've been shortened from 6' to 67-1/2" to keep them from extending past the saw wing casting. There are a couple pics of the saw with fence installed.

Anyway, my storeroom is getting crowded so I though I'd post it for sale. PM if interested.

Price is $500 firm, local pickup only. I'm in the Kennesaw/Acworth/Woodstock area, about 5-10 minutes off I-75 and I-575.

Thanks for looking!
 

Attachments

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top