Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I'm looking for a way to increase the capacity on my table. The stock fence only adjusts out to 3.75 inches. I was wondering if its possible to build a vertical fence that either clamps to the sides of the table or uses the miter slot. I've not used the router much and operating safely is top priority. My initial goal is to route dovetail slots as needed to use the Microjig products for jigs. I was thinking that perhaps someone on here with the same table has solved this. I did search but didn't find anything. Thanks in advance for any ideas.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top