I'm about to rout out my table for the lift.
I have the template, the guide bushings, and have the operation all set up and ready to cut.
This will be done on 3/4 baltic birch.
I see two schools of thought on this kind of operation.
Some say CW and some say CCW.
I've read that CCW will will draw the bit towards the edge of the template for a cleaner, better cut, while others say always cut CW on an inside cut.
What say you?
I have the template, the guide bushings, and have the operation all set up and ready to cut.
This will be done on 3/4 baltic birch.
I see two schools of thought on this kind of operation.
Some say CW and some say CCW.
I've read that CCW will will draw the bit towards the edge of the template for a cleaner, better cut, while others say always cut CW on an inside cut.
What say you?