Router Forums banner

intarsia

5K views 10 replies 6 participants last post by  xplorx4 
#1 ·
Hello, I don't do any routing, but I do a lot of Intarsia work. Does anyone out there do any of that??
 
#2 · (Edited)
Hi jim

Yes .I do ,I'm making the dog in the old shoe right now it's alot of work but it's fun and I can use alot of my scraps of hardwood :) b/4 then get put into the trash can or fire place. :)

I did send off for about 30 full size plans and I have only got two done because the old craftsman scroll saw I had so I got a new Dewalt 20" one that will do the trick. and with the wonder wheel on the grinder, and that helps them come out neat. :)

http://www.intarsia.com/Judy G. Reg. Intarsia p5.html
Item # I-210
http://www.intarsia.com/Judy G. Reg. Intarsia p1 .html


You may want to check out the new item on the Forum

http://www.routerforums.com/wood-scrolling/

and check out the Mikes link for the blades, they are great for intarsia :)
The #3 will cut 3/4" hardwood so clean it's hard to tell it was cut out, it looks like it was stamped out, that clean.

Bj :)

Jim, if you have some snapshots please post some :) I'm sure others would enjoy them also.
 

Attachments

#6 · (Edited)
Hey Corey

Here's one you may want to try :) just for kicks...

It's a Fox Bank :) fun to make and keeps the scraps from going into the fire place.

I make alot of banks and this is just one of them. :)
---------------
WhiteWolft710 may like the last picture (Wolft) :)
--------------
whale is walnut & poplar on a MDF board.

Bj :)
 

Attachments

#10 · (Edited)
Hi

It's a fun thing to do with the scroll saw..and a good way to use up the table scraps :)

Just a place to hang the keys :) see below

========
 

Attachments

#11 ·
Greetings and welcome to the router forum. Thank you for joining us.

BJ that is some amazing work there, I have never heard of Intarsia before today, what kind of wood working art is it?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top