Router Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello...
My name is Laurin. I'm in Dallas and have been the proud owner of a Holzher cosmec 250 CNC since 2002. I have been have difficulty with the tool changer lately and now it's not working at all. When this first started, it was on the drawer part sheets and I found that if I erased the tool operations and retooled all the parts, it would solve the problem. Now, I can't pick up a tool. I've read about getting an industrial electrician, but have no idea where to start looking. I don't think I can afford to go through the manufacturer...
 

·
Retired Moderator
Joined
·
16,385 Posts
Hello Laurin and welcome to the forum. Not everyone reads the introduction posts. If you don't get help with your problem re post with the title "Need help with Holzer Cosmec 250 CNC" and that may get you your answers if you don't get them on this post. There are a bunch of very knowledgeable CNCers on this site.
 

·
Super Moderator
John
Joined
·
6,941 Posts
Hello Laurin,welcome to the forum.
 

·
Official Greeter
Joined
·
18,811 Posts
Welcome to the forum, Laurin.
 

·
Official Greeter
Ross
Joined
·
9,359 Posts
Welcome to the forum Laurin.
 
1 - 5 of 5 Posts
Top