Router Forums banner

Is CO2 a good option?

731 Views 3 Replies 4 Participants Last post by  Flipsaw
Hey all! I'm looking for affordable options for engraving a stumbled upon co2 laser engravers? Are they a good option?
1 - 4 of 4 Posts
Welcome to the forum, Robert! Add your first name to your profile to clear the N/a in the side panel and add your location to your profile, as well.

Relative to what? And what is the intended use?

We do like photos so show us your shop, tools, projects, etc. whenever you're ready. What sort of woodworking are you planning or doing?

Well I like our laser but I am not sure I would call it affordable, I know I could not afford one at home.
If it's just for engraving or very light cutting your might want to look at a diode laser. The Ortur Laser Master 2 in either 15w or 20w.
They will give you more of a work surface than a lot of CO2 desktop models also.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.