Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,591 Posts
I don't know zenbot but typically there is something impeding the axis, either bearings on your rails or your screw. If it's a belt driven machine, could be a slipping belt. Try tightening everything up, check bearings. Pull your stepper(s) to see if the axis moves smoothly by hand.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top