Router Forums banner
1 - 1 of 11 Posts

· Registered
217 Posts
To get a good fit, put your plate on the table where you want it to end up.
Get four pieces of wood all the same thickness. Almost any shape can be used as long as they are longer then your plate.
Use double sided tape AND clamps to build a “frame” around your plate using your four pieces of wood. Remove the plate.
Using a bearing guided bit, route the profile of your plate and get a perfect fit every time. Bonus for using a bit with same radius as the corner of your plate.

In woodworking there is always more then one way to accomplish something.
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.