[PhilBa]

Keep trying to get through. Eventually they will answer.

I have that lift, well the Incra branded version but it's the same mechanism. The lock "dial" doesn't turn that far past the divider between unlocked and locked but it definitely is locked. Also, it doesn't have a positive click when locking or unlocking, just kind of mushes into place. I'm very happy with mine, especially because of the Incra clean sweep plates that allow DC at the router bit.

Good luck and keep us informed of what happens.

 

[PhilBa]

That's good to hear. I think if some one is going to buy the MasteR Lift II, they should buy it from Incra. Not only because of better support but for the magna lock plates that don't need a special tool AND support clean sweep plates for better dust extraction. From JessM, it's a good lift, from Incra, it's a great lift. Perhaps the best out there.

 

[PhilBa]

So, does Incra modify the Jessem lift, or what?

Yes, the Incra version uses a different insert plate - magna lock, they call it. The insert plates are steel and there are little magnets in the base that hold them in place. To remove, you put any long tool (like the lift crank) in the hole and pop it off. No special tool needed. They have replacement plates (clean sweep) with holes that allow DC vacuum to pull the chips down. They have a shroud that you can put under the table that allows a DC hook up or you can build it into your router table like I did. Like I said earlier, it makes a good lift great. The DC is fantastic with it. They sell an upgrade plate, though it's > $100 so probably few takers.

 

[PhilBa]

the plate isn't loose at all. the magnets hold it quite tight and it takes a very good pry to get it off. I'd guess at least 20 to 30 lbs of force. Plus, it's recessed so no lateral force could move it. 7 years of use and one has never come off.