Router Forums banner
1 - 1 of 20 Posts

· Registered
66 Posts
I have a MCLS ? cast iron table extension on my table saw with a 3 1/4 Freud router. Only thing I'd change is to buy the wooden table extension instead of the cast Iron. The table saw gives you a lot more mass for doing edges on 5'+ boards without tipping. I don't mind pulling the router and mounting plate up to change bits and set depth. It gives me just a little more time to think about my setup before I start.
1 - 1 of 20 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.