Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
i was gifted a Jet bandsaw model: JBS 14MW, and I want to attach a fence to the table. But there are no holes due to the age of the saw. Because there are no holes I would have to drill & tap holes in the cast table. In the event that the table cracks does anyone know if the newer table can be retrofitted into my saw?

Thanks
Ryan
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top