Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,907 Posts
You can make an L-shaped fence and clamp it to the table. If you are going to use the fence for resawing (or any other purpose) then you will need to be able to adjust the fence from back to front to compensate for blade drift. A bandsaw does not always cut as straight as a table saw. Another way to cut is to clamp a pointed board to the table and use the point as a pivot for the wood to keep it going straight.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top