Router Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I am beginning to make wooden spoons, approx 9.5 inches long by 1.5 inches wide out of 1X2 oak. I cut the shapes with a sabre saw but need a quicker way to cut the spoons to the correct thickness. The handle end is 3/16 and the bowl end is just under 3/4 inch thick. Any ideas on a jig I can make to speed the process up?
 

·
The Router Guys
Joined
·
768 Posts
Norm Johnson said:
I am beginning to make wooden spoons, approx 9.5 inches long by 1.5 inches wide out of 1X2 oak. I cut the shapes with a sabre saw but need a quicker way to cut the spoons to the correct thickness. The handle end is 3/16 and the bowl end is just under 3/4 inch thick. Any ideas on a jig I can make to speed the process up?
Can you post a photo of the spoons?
 
1 - 2 of 2 Posts
Top