Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I recently got a jointech saw train system which included pretty much everything, even all the templates, original paperwork, and some thick binders of woodworking "notes". I am having one issue though. I was thinking about putting the rails on my table saw but my saw is 27 in deep and the old owners saw wasn't as deep., so the plate is too short (circled in red). I was wondering if anyone knows if the incra baseplate would work with the bracket(circled in green)? I could take actual photos and give measurements if anyone has an incra to measure for me.
Electricity Electrical wiring Audio equipment Gas Engineering

This photo is not mine just an example
 

·
Official Greeter
Joined
·
19,759 Posts
G'day @Mrfee50 , welcome to the forum.
 
1 - 3 of 3 Posts
Top