Router Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 · (Edited)
I couldn't find any other place to to put this.

I got a Vevor Cnc 3018 Pro + 5500mw Laser Engraver Cutter Engraving Machine Offline Controller.

For the price I think it's a good deal.

I have a lot of learning to do. But hoping it all works out.

Anyone else got such a thing?


Electronic instrument Electrical wiring Gas Wire Machine
 

·
Official Greeter
Joined
·
19,838 Posts
Welcome to the forum, @Sanchez77 .

Please show us some pictures of your learning experience with that machine.
 

·
Registered
Joined
·
6 Posts
I don't have one like that but I did recently purchase a Onefinity which I've been very happy with so far. It's my first CNC and I was debating between this and the Carbide but am very happy with my purchase so far. Though I would love to get a laser next!
 

·
Registered
Joined
·
2 Posts
Thats what go me started. Vevor Cnc 3018.
X bearing stuck bad. I got 4 new x linear bearings they stuck, vevor sent me some they stuck.They had 2 short bearings end to end so I got one long bearing to replace 2 short. that fixed it.
I got a bigger y axis motor. It did not seem strong enough and gave out.
upgraded the spindle but the old one was fine. It was slow at first so i got a faster one then..I do not know the old one just ran faster. So have 2 good ones now.
the y axis whole in front did not line up with the motor in back so the screw drive was not inline with the bearing, till I bored out the whole the bearing was in.
now it runs fine. but Im hooked and had to build another.
 
1 - 5 of 5 Posts
Top