Joined
·
31,266 Posts
at about 1/64'' over 4''...
that's good..
1/64'' tolerance is very good... it's wood...
are your resting/holding blocks of uniform thickness...
sawdust got under something somewhere... the block or the rests...
the surface the block rested on had a bump on it...
raised grain will give you that much...
did you face both sides of the block???
what held the milled block down???
that's good..
1/64'' tolerance is very good... it's wood...
are your resting/holding blocks of uniform thickness...
sawdust got under something somewhere... the block or the rests...
the surface the block rested on had a bump on it...
raised grain will give you that much...
did you face both sides of the block???
what held the milled block down???
