[Thompson]

Just finished gluing up all four sides of a toybox (first time gluing up something like this) and after drying, both end pieces came out of the clamps slightly out of square.

They were in square before the clamps went on, but as soon as they do, you lose the ability to put the framing square back on to recheck it. It's not going to help me this time, but I'll know better the next.

Any suggestions?

 

[Thompson]

Thanks for the answers people. I got a raised panel set that came with a glue joint bit for my router table. It puts two tongues & grooves into the board edges.

The finished joint seems like it would do fine to me, but being a glue up rookie, what do I know?