Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
I make keyholes in bracket shelves and two piece (rightangle) shelves which I make - or store bought shelves on the table with a fence. For brackets - I have clamped stops for start, stop and return. For store bought or right angle shelves I mark on the top of the shelf (as it sits on the table for a cut on the bottom) and mark where I want the start and stop to be (one or two or more) I then use my laser sight on the piece to line up the start and lower the piece over the router, move to the stop and return to the start and lift it off. Then to the next spot.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top