Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Hi I am trying to get help with a problem with my Kreg table top stand. I make picture frames and when routing the 1/4 rim for the glass I don’t use the fence. Even if I did it would not get all of the waste. My DEWALT DW618 is mounted on a Kreg lift. I have tried to use a rubber mounded system but that did not work. The size of the top is small. Has any one mounted a box to table. If anyone has had this problem please let me know what your solution was. Kreg has nothing the want me to buy a new table good for them bad for me. I have limited space that’s why the table top stand.
thank you for your help.
 

·
Official Greeter
Joined
·
19,988 Posts
I would use a bearing guided rabet cutter for the cut. Not table mounted, in this case.
 
1 - 2 of 2 Posts
Top