Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
Does anyone else have the Laguna IQ HHC? When I turn the machine on it asks to home the axes but when doing so the Z goes up and jumps around not wanting to stop. The light on the sensor lights up but Z doesn't stop. X&Y home like normal. When moving to any other origin from 1-9 it works fine. Does anyone have a fix for this?
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #4 ·
I'll try switching the axes sensor to see but like I said, it works fine when homing origins 1-9. It's just the Machine home when turning it on. It worked fine before but now its not for some reason. So now I just bypass it and go to my #1 origin. Thanks for you're suggestions.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top