Router Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
589 Posts
Discussion Starter · #1 ·
I was checking to see if anyone might have a lathe chuck that will fit a 3/4 16 tpi spindal. I have been turning with a face plate now would like to try a chuck but dont really want to spend a lot of money on one right off the bat till I have tried one first. So just any old thing will be fine for now.
 

·
Registered
Joined
·
589 Posts
Discussion Starter · #3 ·
Thanks bobj3 for the info I do like the 100.00 one because it selfcenters.
I went to a auction tonight and got a central machinery lathe for 10.00 but it dont have a tail stock or tool rest thought I might make a disc sander out of it ha ha.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top