Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello, i just start to learn something about our Cnc lathe....
It is a Leadwell with fanuc O-T...
When i try to set the home position, the axis goes slowly and after some seconds it came an error. Error 090 - P/S Alarm...

What can i do to not get that alarm?

Some tip?
send [email protected]
 

·
Official Greeter
Joined
·
19,739 Posts
Welcome to the forum. @vuonggnguyen179 .

You may need to come back to this post to see any replies.
 

·
Registered
Mike
Joined
·
3,940 Posts
I'm not familiar with your system but it might be that you are exceeding the limits of travel set in the macro for homing before it gets to the home position. That is a common thing build into many macros to help speed up the process. Try jogging closer to the home position before you use the home function and see if that helps.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top