Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello, i just start to learn something about our Cnc lathe....
It is a Leadwell with fanuc O-T...
When i try to set the home position, the axis goes slowly and after some seconds it came an error. Error 090 - P/S Alarm...

What can i do to not get that alarm?

Some tip?
send [email protected]
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top