Router Forums banner
1 - 7 of 7 Posts

· Registered
254 Posts
Discussion Starter · #1 ·
I knew this was a common practice in the CNC world. But I've never done it before. Job was to cut "Auto Ord" symbol in a case lid. Found the Auto Ord symbol online as a JPG. I downloaded the jpg. Imported JPG into Inkscape program. Exported JPG as a PNG. Imported PNG into Artcam program. Set dimensions, picked tool and saved Gcode. Tested the Gcode on scrap wood. It was good to go. Cut the case lid.
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.