Router Forums banner

Learning To Not Be A Noob To CNC

882 views 9 replies 2 participants last post by  XYlostnoob 
The gcode shows that the cut will start at .9" in X and .4" in Y away from where you set XY0. If this is not what you want to happen, something is off in your CAM software or the post processor you are using. The .crv will show what the tool path should be and if it is not what you are getting, we can work from there. One thing that you may want to try it to set the post processor to grbl inch or grbl mm.
I don't know thet acceptable file types that can be uploaded here, but if .crv is not one of them, you may be able to zip it and upload that. Other than that, I am out of ideas. Sorry.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top