Make sure all the tools in the database are entered correctly.
Check the soft limits that are set to make sure they fit the working area of the machine.
Make sure the machine resets to 0,0,0 when homed or whatever the homing routine is set for.
Make sure the units of measure are correct for the file you are trying to cut.
Make sure the project is not designed so the gcode runs the bit to or past the limits.
Check the soft limits that are set to make sure they fit the working area of the machine.
Make sure the machine resets to 0,0,0 when homed or whatever the homing routine is set for.
Make sure the units of measure are correct for the file you are trying to cut.
Make sure the project is not designed so the gcode runs the bit to or past the limits.
