Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
457 Posts
Discussion Starter · #1 ·
I have been getting emails asking questions about john walsh's drawing boards
asking about the quality of the dxf file and the number of nodes produced so I put together a video
to demo and explain a bit

 

Attachments

·
Registered
Joined
·
457 Posts
Discussion Starter · #3 ·
its has been my experience that if you cut down on the nodes doing a circle it will look like a multipoint star
His software has a circle command , you can touch 3 points and it will create the circle perfectly and 100% accurate
but using the drawing commands you have to select more than 7 nodes , I use around 35 to 40
 

·
Registered
Joined
·
457 Posts
Discussion Starter · #5 ·
well I can only speak from my experience and I have cut back on nodes to the point that it looked like a star, but in john's software there is a
circle draw command and you only touch 3 points and it creates a circle 100% accurate.
The program even asks if the dia is ### so you can then change it.
I have not used illustrator but have looked at it for node editing and I prefer aspire for node work
But I do see what you have shown
 
1 - 3 of 3 Posts
Top