Router Forums banner
1 - 2 of 2 Posts

· Banned
Joined
·
12,004 Posts
Mary Ann, there are a wide variety of slot cutters available; perhaps you would care to specify what size you need? If you visit woodcraft.com and rockler.com you can check to see if there is a store close to you. The stores often have a list of local craftsmen looking for work. You can find low cost slot cutters/arbors at MLCS.com with free shipping. Rockler sells a small router table that uses a trim router, this should be perfect for your application
 

Attachments

· Banned
Joined
·
12,004 Posts
I'm not sure I follow you on this Dan? Clamping jigs and fixtures is commonplace; the bit is guarded... this is a good solution.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top