Router Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Was looking at Amana for tambor doors , does anyone out there use this one
and if you do is there away to super size it or get off the shelves cutters
to do large panals with a table top router.

Thanks for your time on this.
Dogtrot
 

·
Registered
Joined
·
23,786 Posts
Hi Dogtrot

You could use the Train Track Router Bits to get it to the super size..I think it would work.. :)

Train Track Router Bits
MLCS bullnose and train track router bits


========


Was looking at Amana for tambor doors , does anyone out there use this one
and if you do is there away to super size it or get off the shelves cutters
to do large panals with a table top router.

Thanks for your time on this.
Dogtrot
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
Thanks for the tip , will check it out. What I'm doing is large bookmatch panals
for a screen and the hinge system is something I have design (to show soon )
don't want to let the cat out of the bag till I have the bugs work out
Thanks again.

The Dogtrot
Like your hot rod, you build it ?
 

·
Registered
Joined
·
23,786 Posts
HI Geoff

You'er Welcome and thanks

" Like your hot rod, you build it ? "

For most part and with help of the little one below,she is now a better mechanic than I am ,,,but Ford did most of the work :)

========

Thanks for the tip , will check it out. What I'm doing is large bookmatch panals
for a screen and the hinge system is something I have design (to show soon )
don't want to let the cat out of the bag till I have the bugs work out
Thanks again.

The Dogtrot
Like your hot rod, you build it ?
 

Attachments

·
Registered
Joined
·
1,683 Posts
Was looking at Amana for tambor doors , does anyone out there use this one
and if you do is there away to super size it or get off the shelves cutters
to do large panals with a table top router.

Thanks for your time on this.
Dogtrot
Saw an article from IIRC, Shopnotes, on this the other day, with a fairly expensive set of cutters offered. The MLCS ones sound more economical. BTW, I was rooting through some old papers the other day and found a 93 catalogue of theirs and some correspondence. Is it still Bob and Merle?

Cheers

Peter
 

·
Registered
Joined
·
11,921 Posts
Another source for custom router bits is Whiteside. Beside making the top quality bits to be had they also do custom work. Contact them for a quote.
 

·
Registered
Joined
·
23,786 Posts
HI Deb

I think so, she was always covered from head to toe with grease ,when she got her 1st. car she pulled the trans.out and rebuilt it...all with only one hand..she is my pride and joy... she now has two of her own little ones and she will call me from time to time asking me to tell her husband that she is right about some type of car repair...hahahahaha LOL LOL

But I knew that was coming when she was about 7 she drove her bike right into the grease pit, I had in my garage ,it was about 7ft deep and she said I'm fine how do I get out of here with a tear or two in her eye.. LOL LOL ,,she put my boys to shame most of the time LOL LOL ,sharp as a tack all the time..my P and J all the time..




Bob good for you for enlisting the help of the little one. I bet she loved every minute of it!
 
1 - 8 of 8 Posts
Top