Router Forums banner
1 - 2 of 2 Posts

·
Administrator
David - Machinist in wood
Joined
·
4,405 Posts
When I built the cross for our church I resawed both the Walnut and Curly Maple down to about 1/4" for some pieces and 5/16" for others. The boards were 7" to 9" wide and about 7' to 8' long. I ran them through the planer to clean up a bit and then through the drum sander for final thicknessing.

How wide can you resaw a board?

David
 

·
Administrator
David - Machinist in wood
Joined
·
4,405 Posts
If you plan on going the veneer route, check with Certainly Wood in NY. I've been buying from them since they opened in the 80's and they often have thicker veneers available.

David
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top