[RainMan 2.0]

He shipped quite a few really bad machines, and really ruined his reputation.

It’s unfortunate. I was going to order one myself till I talked with a guy in my province who had purchased one .
I had concerns about the bed being flat , and sure as heck this guys table had a strut that was welded in place higher than the others .
I guess going over the spoil board with the bit may help depending on how much the discrepancy is .
I would have cut it and welded it back . But you shouldn’t have to .
I’m back to cncrouterparts as usual

 

[RainMan 2.0]

That's minor. Many people had twisted, non square frames, with non parallel linear rails, and gear racks out of alignment. He shipped several machines that were completely unusable. This is on top of the fact that he's always been terrible with support, and customer contact.

I haven’t been on CNCZone for quite some time , and just went threw some of the threads.
Do I ever feel for these poor people . It’s sad ,especially when theirs people who have always had his back . The situation isn’t even fixable imo